Version 7.6.1.0 Introduced on the S-Series.Version 7.5.1.0 Introduced on the C-Series.pre-Version6.1.1.0Introduced on the E-Series.UsageInformationThis command provides egress port information for a given IP flow. This is useful in identifyingwhich interface the packet follows in the case of Port-channel and Equal Cost Multi Paths. Usethis command for routed packed only. For switched packets, use the show port-channel-flow command.The show ip flow command does not compute the egress port information when load-balance mac hashing is also configured due to insufficient information (the egress MACis not available).S-Series produces the following error message: %Error: Unable to read IP routetable.C-Series produces the message: %Error: FIB cannot compute the egressport with the current trunk hash setting.Example FTOS#show ip flow interface Gi 1/8 189.1.1.1 63.0.0.1 protocoltcp source-port 7898 destination-port 8flow: 189.1.1.1 63.0.0.1 protocol 6 7868 8976Ingress interface:Gi 1/20Egress interface:Gi 1/14 to 1.7.1.2[CAM hit 103710]unfragmented packetGi 1/10 to 1.2.1.2[CAM hit 103710] fragmentedpacketshow ip interfaceView IP-related information on all interfaces.C-Series, E-Series, S-Series, Z-Series, S4810Syntax show ip interface [interface | brief | linecard slot-number][configuration]Parametersinterface (OPTIONAL) Enter the following keywords and slot/port or numberinformation:• For a 1-Gigabit Ethernet interface, enter the keywordGigabitEthernet followed by the slot/port information.• For a Loopback interface, enter the keyword Loopbackfollowed by a number from 0 to 16383.• For the Management interface, enter the keywordManagementEthernet followed by zero (0).• For the Null interface, enter the keyword null followed byzero (0).817
