ip msdp peerConfigure an MSDP peer.E-Series, Z-Series, S4810Syntax ip msdp peer peer address [connect-source] [description] [sa-limit number]To remove the MSDP peer, use the no ip msdp peer peer address [connect-source interface] [description name] [sa-limit number] command.Parameterspeer address Enter the peer address in a dotted decimal format (A.B.C.D.).connect-sourceinterfaceEnter the keywords connect-source followed by one of theinterfaces and slot/port or number information:• For a Fast Ethernet interface, enter the keywordFastEthernet followed by the slot/ port information.• For a 1-Gigabit Ethernet interface, enter the keywordGigabitEthernet followed by the slot/port information.• For a Loopback interface, enter the keyword loopbackfollowed by a number from 0 to 16383.• For a Port Channel interface, enter the keywords port-channel followed by a number. For the E-Series, the rangeis 1 to 255 for TeraScale and 1 to 512 for ExaScale.• For a SONET interface, enter the keyword sonet followed bythe slot/port information.• For a 10-Gigabit Ethernet interface, enter the keywordTenGigabitEthernet followed by the slot/portinformation.• For a 40-Gigabit Ethernet interface, enter the keywordfortyGigE followed by the slot/port information.• For a VLAN, enter the keyword vlan followed by a numberfrom 1 to 4094.description name (OPTIONAL) Enter the keyworddescription followed by a descriptionname (maximum 80 characters) to designate a description for theMSDP peer.sa-limitnumber (OPTIONAL) Enter the maximum number of SA entries in SA-cache.The range is 1 to 500000. The default it 500000.Defaults as aboveCommand Modes CONFIGURATIONCommand History Version 8.3.11.1 Introduced on the Z9000.Version 8.3.7.0 Introduced on the S4810.Version 8.5.1.0 Added support for 4-port 40G line cards on ExaScale.Version 7.5.1.0 Added option for SA upper limit and the description option.983
