UsageInformationYou must enter the class-map command in order to access this command. You can matchagainst only one VLAN ID.RelatedCommandsclass-map – identifies the class map.policy-aggregateAllow an aggregate method of configuring per-port QoS via policy maps. An aggregate QoS policy is part of the policymap (input/output) applied on an interface.C-Series, E-Series, S-Series, Z-Series, S4810Syntax policy-aggregate qos-policy-nameTo remove a policy aggregate configuration, use the no policy-aggregate qos-policy-name command.Parametersqos-policy-name Enter the name of the policy map in character format (32 charactersmaximum).Defaults noneCommand Modes CONFIGURATION (policy-map-input and policy-map-output)Command History Version 8.3.11.1 Introduced on the Z9000.Version 8.3.7.0 Introduced on the S4810.Version 8.2.1.0 Policy name character limit increased from 16 to 32.Version 7.6.1.0 Introduced on the S-Series.Version 7.5.1.0 Introduced on the C-Series.pre-Version6.1.1.1Introduced on the E-Series.UsageInformationC-Series and S-SeriesAggregate input/output QoS policy applies to all the port ingoing/outgoing traffic. Aggregateinput/output QoS policy can coexist with per queue input/output QoS policies.1. If only aggregate input QoS policy exists, input traffic conditioning configurations (rate-police) apply. Any marking configurations in aggregate input QoS policy are ignored.2. If aggregate input QoS policy and per class input QoS policy coexist, aggregate input QoSpolicy preempts per class input QoS policy on input traffic conditioning (rate-police). Inother words, if rate police configuration exists in the aggregate QoS policy, the ratepolice configurations in per class QoS are ignored. Marking configurations in per classinput QoS policy still apply to each queue.E-Series1201
