Parametersip-address Enter an IP address in dotted decimal format of the network.mask Enter the mask of the IP address in the slash prefix length format (forexample, /24).The mask appears in command outputs in dotted decimal format(A.B.C.D).route-mapmap-name(OPTIONAL) Enter the keyword route-map followed by the name ofan established route map.Only the following ROUTE-MAP mode commands are supported:• match ip address• set community• set local-preference• set metric• set next-hop• set origin• set weightIf the route map is not configured, the default is deny (to drop allroutes).Defaults Not configured.Command Modes ROUTER BGPCommand History Version 8.3.11.1 Introduced on the Z9000.Version 8.3.7.0 Introduced on the S4810.Version 7.8.1.0 Introduced on the S-Series.Version 7.7.1.0 Introduced on the C-Series.UsageInformationFTOS software resolves the network address configured by the network command with theroutes in the main routing table to ensure that the networks are reachable using non-BGProutes and non-default routes.RelatedCommandsredistribute – redistributes routes into BGP.network backdoorSpecify this IGP route as the preferred route.C-Series, E-Series, S-Series, Z-Series, S4810Syntax network ip-address mask backdoorTo remove a network, use the no network ip-address mask backdoor command.Parametersip-address Enter an IP address in dotted decimal format of the network.381
