Version 7.5.1.0 Introduced on the C-Series.E-Series legacycommandUsageInformationFor this snmp-server trap-source command to be enabled, you must configure an IPaddress on the interface and enable the interface configured as an SNMP trap source.RelatedCommandssnmp-server community – sets the community string.snmp-server userConfigure a new user to an SNMP group.C-Series, E-Series, S-Series, Z-SeriesSyntax snmp-server user name {group_name remote ip-address udp-portport-number} [1 | 2c | 3] [encrypted] [auth {md5 | sha} auth-password] [priv des56 priv password] [access access-list-name |ipv6 access-list-name | access-list-name ipv6 access-list-name]To remove a user from the SNMP group, use the no snmp-server user name{group_name remote ip-address udp-port port-number} [1 | 2c |3] [encrypted] [auth {md5 | sha} auth-password] [priv des56priv password] [access access-list-name | ipv6 access-list-name| access-list-name ipv6 access-list-name] command.Parametersname Enter the name of the user (not to exceed 20 characters), on the hostthat connects to the agent.group_name Enter a text string (up to 20 characters long) as the name of the group.The following groups are created for mapping to read/writecommunity/security-names (defaults):• v1v2creadu — maps to a community with ro permissions.• 1v2cwriteu — maps to a community rw permissions.remoteip-addressEnter the keywords udp-port followed by the user datagramprotocol (UDP) port number on the remote device. The range is 0 to65535. The default is 162.udp-portport-numberEnter the keywords udp-port followed by the UDP (User DatagramProtocol) port number on the remote device. The range is 0 to 65535.The default is 162.1 | 2c | 3 (OPTIONAL) Enter the security model version number (1, 2c, or 3):• 1 is the least secure version.• 3 is the most secure of the security modes.• 2c allows transmission of informs and counter 64, whichallows for integers twice the width of what is normallyallowed.The default is 1.1376
