as-path-name Enter the name of an established AS-PATH access list. If you do notconfigure the AS-PATH access list, the default is permit (to allowroutes). The maximum is 16 characters.in Enter the keyword in to filter inbound BGP routes.out Enter the keyword out to filter outbound BGP routes.Defaults Not configured.Command Modes ROUTER BGPV6-ADDRESS FAMILYCommand History Version 8.2.1.0 Introduced on the E-Series ExaScale.Version 7.4.1.0 Introducedneighbor maximum-prefixControl the number of network prefixes received.C-Series, E-SeriesSyntax neighbor {ipv6-address | peer-group-name} maximum-prefixmaximum [threshold] [warning-only]To return to the default values, use the no neighbor {ipv6-address | peer-group-name} maximum-prefix maximum [threshold] [warning-only]command.Parametersipv6-address Enter the IPv6 address in the x:x:x:x::x format.NOTE: The :: notation specifies successive hexadecimal fields ofzeros.peer-group-name Enter the name of the peer group.maximum Enter a number as the maximum number of prefixes allowed for thisBGP router. The range is 1 to 4294967295.threshold (OPTIONAL) Enter a number to be used as a percentage of themaximum value. When the number of prefixes reaches thispercentage of the maximum value, the E-Series software sends amessage. The range is 1 to 100 percent. The default is 75.warning-only (OPTIONAL) Enter the keywords warning-only to set the router tosend a log message when the maximum value is reached. If you donot set this parameter, the router stops peering when the maximumnumber of prefixes is reached.Defaults threshold = 75Command Modes ROUTER BGPV6-ADDRESS FAMILYCommand History Version 8.2.1.0 Introduced on the E-Series ExaScale.485
