storm-control multicast (Configuration)Configure the packets per second (pps) of multicast traffic allowed in to the C-Series and S-Series networks only.C-Series, S-Series, Z-Series, S4810Syntax storm-control multicast packets_per_second inTo disable storm-control for multicast traffic into the network, use the no storm-controlmulticast packets_per_second in command.Parameterspackets_per_second inC-Series and S-Series Only: Enter the packets per second of multicasttraffic allowed into the network. The range is 0 to 33554431.Defaults noneCommand Modes CONFIGURATION (conf)Command History Version 8.3.11.1 Introduced on the Z9000.Version 8.3.7.0 Introduced on the S4810.Version 7.6.1.0 Introduced on the C-series and S-Series.UsageInformationBroadcast traffic (all 0xFs) should be counted against the broadcast storm control meter, notagainst the multicast storm control meter. It is possible, however, that some multicast controltraffic may get dropped when storm control thresholds are exceeded.storm-control multicast (Interface)Configure the percentage of multicast traffic allowed on an C-Series or S-Series interface (ingress only) network only.C-Series, S-Series, Z-Series, S4810Syntax storm-control multicast packets_per_second inTo disable multicast storm control on the interface, use the no storm-controlmulticast packets_per_second in command.Parameterspackets_per_second inC-Series and S-Series Only: Enter the packets per second ofbroadcast traffic allowed into the network. The range is 0 to 33554431.Defaults noneCommand Modes INTERFACE (conf-if-interface-slot/port)Command History Version 8.3.11.1 Introduced on the Z9000.Version 8.3.7.0 Introduced on the S4810.1407
