Command History Version 8.3.11.1 Introduced on the Z9000.Version 8.3.7.0 Introduced on the S4810.Version 8.1.1.0 Introduced on the E-Series ExaScale.Version 7.8.1.0 Introduced on the C-Series for the port-channels and the S-Series.Version 7.7.1.0 Introduced on the E-Series.Example FTOS(conf)# ip access-list extended iptv-channelsFTOS(config-ext-nacl)# permit ip 10.1.2.3/24 225.1.1.0/24FTOS(config-ext-nacl)# permit ip any 232.1.1.0/24FTOS(config-ext-nacl)# permit ip 100.1.1.0/16 anyFTOS(config-if-gi-1/1)# ip pim join-filter iptv-channels inFTOS(config-if-gi-1/1)# ip pim join-filter iptv-channels outRelatedCommandsip access-list extended – configure an access list based on IP addresses or protocols.ip pim neighbor-filterConfigure this feature to prevent a router from participating in protocol independent multicast (PIM).C-Series, E-Series, S-Series, Z-Series, S4810Syntax ip pim neighbor-filter {access-list}To remove the restriction, use the no ip pim neighbor-filter {access-list}command.Parametersaccess-list Enter the name of a standard access list. Maximum 16 characters.Defaults noneCommand Modes CONFIGURATIONCommand History Version 8.3.11.1 Introduced on the Z9000.Version 8.3.7.0 Introduced on the S4810.Version 8.1.1.0 Introduced on the E-Series ExaScale.Version 7.8.1.0 Introduced on the C-Series and S-Series.Version 7.6.1.0 Introduced on the E-Series.UsageInformationDo not enter this command before creating the access-list.1134
