adv-routerip-address(OPTIONAL) Enter the keywords adv-router followed by the IPaddress of an Advertising Router to display only the LSA informationabout that router.Command Modes • EXEC• EXEC PrivilegeCommand History Version 8.3.11.1 Introduced on the Z9000.Version 8.3.7.0 Introduced on the S4810.Version 7.8.1.0 Added support for Multi-Process OSPF.Version 7.6.1.0 Introduced on the S-Series.Version 7.5.1.0 Introduced on the C-Series.pre-Version6.1.1.1Introduced on the E-Series.RelatedCommandsshow ip ospf database – displays OSPF database information.show ip ospf database routerDisplay the router (type 1) LSA information.C-Series, E-Series, S-Series, Z-Series, S4810Syntax show ip ospf process-id database router [link-state-id] [adv-router ip-address]Parametersprocess-id Enter the OSPF Process ID to show a specific process. If no ProcessID is entered, command applies only to the first OSPF process.link-state-id (OPTIONAL) Specify LSA ID in dotted decimal format. The LSA IDvalue depends on the LSA type, and it can be one of the following:• the network’s IP address for Type 3 LSAs or Type 5 LSAs• the router’s OSPF router ID for Type 1 LSAs or Type 4 LSAs• the default destination (0.0.0.0) for Type 5 LSAsadv-routerip-address(OPTIONAL) Enter the keywords adv-router followed by the IPaddress of an Advertising Router to display only the LSA informationabout that router.Command Modes • EXEC• EXEC PrivilegeCommand History Version 8.3.11.1 Introduced on the Z9000.1086
