Version 8.1.1.0 Introduced on the E-Series ExaScale.Version 7.7.1.0 Introduced on the S-Series.Version 7.6.1.0 Introduced on the C-Series.Version 6.2.1.1 Introduced on the E-Series.UsageInformationThis command changes the sampling rate for an Interface. By default, the sampling rate of aninterface is set to the same value as the current global default sampling rate. If the valueentered is not a correct power of 2, the command generates an error message with theprevious and next power-of-2 value. Select one of these two number and re-enter thecommand.RelatedCommandssflow sample-rate (Global) – changes the sampling rate globally.show sflowDisplay the current sFlow configuration.C-Series, E-Series, S-Series, Z-Series, S4810Syntax show sflow [interface]Parametersinterface (OPTIONAL) Enter the following keywords and slot/port or numberinformation:• For an 100/1000 Ethernet interface, enter the keywordGigabitEthernet followed by the slot/port information.• For a 1-Gigabit Ethernet interface, enter the keywordGigabitEthernet followed by the slot/port information.• For a Loopback interface, enter the keyword loopbackfollowed by a number from 0 to 16383.• For a SONET interface, enter the keyword sonet followed bythe slot/port information.• For a 10-Gigabit Ethernet interface, enter the keywordTenGigabitEthernet followed by the slot/portinformation.Command Modes • EXEC• EXEC PrivilegeCommand History Version 8.3.11.1 Introduced on the Z9000.Version 8.3.7.0 Introduced on the S4810.Version 8.2.1.0 Introduced on S-Series Stacking.1358
