NOTE: If a route has a mask greater than 64, no output is displayed and no output isdisplayed for show ipv6 cam stack-unit unit-number port-set {0-1}ipv6-address, but an equivalent /64 entry would be listed in the show ipv6 camstack-unit unit-number port-set {0-1} output. Similarly, if there is morethan one ECMP object with a destination route that has a mask greater than 64, if the first64 bits in the destination routes of the ECMP objects are the same, only one route isinstalled in CAM even though multiple ECMP path entries exist.NOTE: On the S4810, the self address is displayed in the neighbor portion for the showipv6 cam stack-unit unit-number port-set command.show ipv6 control-plane icmpDisplays the status of the icmp control-plane setting for the error eate limit setting.S4810Syntax show ipv6 control-plane icmpDefault 100Command Modes EXECCommand History Version 8.3.12.0 Introduced on the S4810.RelatedCommandsipv6 flowlabel-zero – Configure IPv6 address auto-configuration for the management interface.show ipv6 fib linecardView all forwarding information base (FIB) entries.C-Series, E-SeriesSyntax show ipv6 fib linecard slot-number {summary | ipv6-address}Parametersslot-number Enter the number of the line card slot. E-Series. The range is 0 to 13on a E1200, 0 to 6 on a E600/E600i, and 0 to 5 on a E300.summary (OPTIONAL) Enter the keyword summary to view a summary ofentries in IPv6 cam.ipv6-address Enter the IPv6 address in the x:x:x:x::x/n format to display networksthat have more specific prefixes. The range is /0 to /128.848
