Version 7.8.1.0 Increased the name string to accept up to 140 characters. Prior to7.8.1.0, names were up to 16 characters long.Version 7.6.1.0 Introduced on the S-Series.Version 7.5.1.0 Introduced on the C-Series.pre-Version6.2.1.1Introduced on the E-Series.UsageInformationYou can assign one ACL (standard or extended ACL) to an interface.NOTE: This command supports Loopback interfaces EE3 and EF series route processormodules (RPMs). This command does not support Loopback interfaces ED series RPMs, C-Series or S-Series Loopback interfaces.When you apply an ACL that filters IGMP traffic, all IGMP traffic is redirected to the CPUs andsoft-forwarded, if required, in the following scenarios:• on a Layer 2 interface - if a Layer 3 ACL is applied to the interface• on a Layer 3 port or on a Layer 2/Layer 3 portRelatedCommandsip access-list standard – configures a standard ACL.ip access-list extended – configures an extended ACL.ip control-plane egress-filterEnable egress Layer 3 ACL lookup for IPv4 CPU traffic.Z-Series, S4810Syntax ip control-plane egress-filterDefaults Not enabled.Command Modes EXEC PrivilegeCommand History Version 8.3.11.1 Introduced on the Z9000.show ip accounting access-listDisplay the IP access-lists created on the switch and the sequence of filters.C-Series, E-Series, S-Series, Z-Series, S4810Syntax show ip accounting {access-list access-list-name | cam_count}interface interfaceParametersaccess-list-name Enter the name of the ACL to be displayed.cam_count List the count of the CAM rules for this ACL.interfaceinterfaceEnter the keyword interface followed by the one of the followingkeywords and slot/port or number information:216
