ip pim rp-candidateConfigure a PIM router to send out a Candidate-RP-Advertisement message to the bootstrap (BS) router or define groupprefixes that are defined with the RP address to PIM BSR.C-Series, E-Series, S-Series, Z-Series, S4810Syntax ip pim rp-candidate {interface [priority]To return to the default value, use the no ip pim rp-candidate {interface[priority] command.Parametersinterface Enter the following keywords and slot/port or number information:• For a Gigabit Ethernet interface, enter the keywordGigabitEthernet followed by the slot/port information.• For a Loopback interface, enter the keyword loopbackfollowed by a number from 0 to 16383.• For a Port Channel interface, enter the keywords port-channel followed by a number. For the C-Series and S-Series, the range is 1 to 128. For the E-Series, the range is 1 to255 for TeraScale and 1 to 512 for ExaScale.• For a SONET interface, enter the keyword sonet followed bythe slot/ port information.• For a 10-Gigabit Ethernet interface, enter the keywordTenGigabitEthernet followed by the slot/portinformation.• For a VLAN, enter the keyword vlan followed by a numberfrom 1 to 4094.priority (OPTIONAL) Enter the priority used in Bootstrap election process. Therange is zero (0) to 255. The default is 192.Defaults Not configured.Command Modes CONFIGURATIONCommand History Version 8.3.11.1 Introduced on the Z9000.Version 8.3.7.0 Introduced on the S4810.Version 8.1.1.0 Introduced on the E-Series ExaScale.Version 7.8.1.0 Introduced on the S-Series.pre-Version6.1.1.1Introduced on the E-Series.UsageInformationPriority is stored at BSR router when receiving a Candidate-RP-Advertisement.1137
