cam-aclAllocate CAM for IPv4 and IPv6 ACLs.C-Series, S-Series, Z-SeriesSyntax cam-acl {default | l2acl number ipv4acl number ipv6acl number,ipv4qos number l2qos number, l2pt number ipmacacl numberecfmacl number [vman-qos | vman-dual-qos number}openflow {4|8}Parameters default Use the default CAM profile settings and set the CAM as follows:• L3 ACL (ipv4acl): 6• L2 ACL(l2acl): 5• IPv6 L3 ACL (ipv6acl): 0• L3 QoS (ipv4qos): 1• L2 QoS (l2qos): 1• OpenFlow: 0 (disabled)l2aclnumberipv4aclnumberipv6aclnumber,ipv4qosnumberl2qosnumber,l2ptnumberipmacaclnumberecfmaclnumber[vman-qos |vman-dual-qosnumberAllocate space to each CAM region.Enter the CAM profile name followed by the amount of CAM space tobe allotted. The total space allocated must equal 13. The ipv6aclrange must be a factor of 2.Enter 4 or 8 for the number of OpenFlow FP blocks.• 4: Creates 242 entries for use by the OpenFlow controller (256total entries minus the 14 entries reserved for internalfunctionality)• 8: Creates 498 entries for use by the OpenFlow controller (512total entries minus the 14 entries reserved for internalfunctionality)Command Modes CONFIGURATIONCommand History Version 9.1.(0.0) Added support for OpenFlow.Version 8.3.11.1 Introduced on the Z9000.Version 8.3.1.0 Added the keywords ecfmacl, vman-qos, and vman-dual-qos.Version 8.2.1.0 Introduced on the S-Series.Version 7.8.1.0 Introduced on the C-Series.UsageInformationYou must save the new CAM settings to the startup-config (write-mem or copy runstart) then reload the system for the new settings to take effect.The total amount of space allowed is 16 FP Blocks. System flow requires three blocks andthese cannot be reallocated. The ipv4acl profile range is 1 to 4.When configuring space for IPv6 ACLs, the total number of Blocks must equal 13.548
