Version 8.3.7.0 Introduced on the S4810.Version 7.6.1.0 Introduced on the S-Series.Version 7.5.1.0 Introduced on the C-Series.pre-Version6.2.1.1Introduced on the E-Series.prioritySpecify a VRRP priority value for the VRRP group. This value is used by the VRRP protocol during the MASTER electionprocess.C-Series, E-Series, S-Series, Z-Series, S4810Syntax priority priorityTo return to the default value, use the no priority command.Parameterspriority Enter a number as the priority. Enter 255 only if the router’s virtualaddress is the same as the interface’s primary IP address (that is, therouter is the OWNER). The range is 1 to 255. The default is 100.Defaults 100Command Modes VRRPCommand History Version 8.3.11.1 Introduced on the Z9000.Version 8.3.7.0 Introduced on the S4810.Version 7.6.1.0 Introduced on the S-Series.Version 7.5.1.0 Introduced on the C-Series.pre-Version6.2.1.1Introduced on the E-Series.UsageInformationTo guarantee that a VRRP group becomes MASTER, configure the VRRP group’s virtualaddress with same IP address as the interface’s primary IP address and change the priority ofthe VRRP group to 255.If you set the priority command to 255 and the virtual-address is not equal to theinterface’s primary IP address, an error message appears.show configView the non-default VRRP configuration.C-Series, E-Series, S-Series, Z-Series, S4810Syntax show config [verbose]1476
