0 About this manual0.2 Target group12 Gateway XN-312-GW-CAN 06/16 MN050003-EN www.eaton.eu0.2 Target groupThis manual is intended for automation technicians and engineers.Extensive knowledge of how to work with the field bus being used will makeit easier to understand the contents of this manual.A specialist knowledge of electrical engineering is needed for commissioningand programming.0.3 Legal DisclaimerAll information in this operator manual was provided by us to the best of ourknowledge and belief and in accordance with the current state-of-the-art.However, this does not exclude the possibility of inaccuracies so that wecannot accept any liability for the accuracy and completeness of the informa-tion. In particular, this information does not guarantee any particular proper-ties.The devices described here must only be set up and operated as specified inthis manual and in the installation instructions provided with the device.Installation, commissioning, operation, maintenance and refitting of thedevices must only be carried out by qualified persons. The devices must onlybe used in the areas recommended and only in conjunction with third-partydevices and components that have been approved by us.Only use is techni-cally faultless condition is permitted. Fault-free and safe operation of the sys-tem requires proper transport, storage, installation and commissioning aswell as careful operation and maintenance.If the following safety instructionsare not observed, particularly with regard to commissioning and maintenanceof the devices by insufficiently qualified personnel and/or in the event ofimproper use of the devices, any hazards caused by the devices cannot beexcluded. We assume no liability for any injury or damages incurred.06/16 178 Expansion for sensor selection„XN-322-4AI-PTNI“ ✓The following chapters were added:106 → Section “7.1 XN-322-8DI-PD” ✓109 → Section “7.2 XN-322-16DI-PD” ✓125 → Section “7.6 XN-322-20DI-ND” ✓128 → Section “7.7 XN-322-4DO-RNO” ✓131 → Section “7.8 XN-322-8DO-P05” ✓143 → Section “7.11 XN-322-8DIO-PD05” ✓148 → Section “7.12 XN-322-16DIO-PD05” ✓153 → Section “7.13 XN-322-16DIO-PC05” ✓234 → Section “7.19 XN-322-4AIO-U2” ✓266 → Section “7.21 XN-322-4AIO-I” ✓284 → Section “7.22 XN-322-8AIO-I” ✓