• For VLAN interface, enter the keyword vlan then anumber from 1 to 4094.• For a tunnel interface, enter the keyword tunnel.Defaults The IP address on the system that is closest to the Telnet address is used in theoutgoing packets.Command Modes CONFIGURATIONCommand History This guide is platform-specific. For command information about other platforms, referto the relevant Dell Networking OS Command Line Reference Guide.The following is a list of the Dell Networking OS version history for this command.Version Description9.9(0.0) Introduced on the C9010.9.2(1.0) Introduced on the Z9500.8.3.19.0 Introduced on the S4820T.8.3.11.1 Introduced on the Z9000.8.3.7.0 Introduced on the S4810.8.5.1.0 Added support for 4-port 40G line cards on ExaScale.8.2.1.0 Increased number of VLANs on ExaScale to 4094 (was 2094).8.1.1.0 Introduced on the E-Series ExaScale.7.6.1.0 Introduced on the S-Series.7.5.1.0 Introduced on the C-Series.E-Series Original commandRelatedCommandstelnet — telnets to another device.ip tftp source-interfaceAssign an interface’s IP address in outgoing packets for TFTP traffic.C9000 SeriesSyntax ip tftp source-interface interfaceControl and Monitoring 101
