Example Dell#confDell(conf)# ip ssh rhostsfile flash://shostsDell(conf)#Usage Information This command specifies the rhost file used for host-based authentication. Thiscreates/ file overwrites the flash:/ADMIN_DIR/ssh/shosts file and deletes theuser-specified file. Even though this command is a global configuration command, itdoes not appear in the running configuration because you only need to run thiscommand once.This file contains hostnames and usernames, for which hosts and users, rhost-authentication can be allowed.NOTE: For rhostfile and pub-key-file, the administrator must FTP the fileto the switch.ip ssh rsa-authentication (Config)Enable RSA authentication for the SSHv2 server.C9000 SeriesSyntax ip ssh rsa-authentication enableTo disable RSA authentication, use the no ip ssh rsa-authentication enablecommand.Parameters enable Enter the keyword enable to enable RSA authentication for theSSHv2 server.Defaults Disabled.Command Modes CONFIGURATIONCommand History This guide is platform-specific. For command information about other platforms, referto the relevant Dell Networking OS Command Line Reference Guide.The following is a list of the Dell Networking OS version history for this command.Version Description9.9(0.0) Introduced on the C9010.9.2(1.0) Introduced on the Z9500.8.3.19.0 Introduced on the S4820T.8.3.11.1 Introduced on the Z9000.8.3.7.0 Introduced on the S4810.Security 1994
