• If 802.1X authorization is enabled and all information from the RADIUS server is valid, the port is placedin the specified VLAN after authentication.• If port security is enabled on an 802.1X port with VLAN assignment, the port is placed in the RADIUSserver assigned VLAN.• If 802.1X is disabled on the port, it is returned to the configured access VLAN.• When the port is in the Force Authorized, Force Unauthorized, or Shutdown state, it is placed in theconfigured access VLAN.• If an 802.1X port is authenticated and put in the RADIUS server assigned VLAN, any change to the portaccess VLAN configuration does not take effect.• The 802.1X with VLAN assignment feature is not supported on trunk ports, dynamic ports, or withdynamic-access port assignment through a VLAN membership.dot1x authentication (Configuration)Enable dot1x globally. Enable dot1x both globally and at the interface level.C9000 SeriesSyntax dot1x authenticationTo disable dot1x globally, use the no dot1x authentication command.Defaults DisabledCommand Modes CONFIGURATIONCONFIGURATION TERMINAL BATCHCommand History This guide is platform-specific. For command information about other platforms, referto the relevant Dell Networking OS Command Line Reference Guide.The following is a list of the Dell Networking OS version history for this command.Version Description9.10(0.0) Introduced the Configuration Terminal Batch mode on C9010.9.9(0.0) Introduced on the C9010.9.2(1.0) Introduced on the Z9500.8.3.19.0 Introduced on the S4820T.8.3.12.0 Introduced on the S4810.8.3.11.1 Introduced on the Z9000.7.6.1.0 Introduced on the C-Series and S-Series.7.4.1.0 Introduced on the E-Series TeraScale.Security 1964
