Version Description9.2(0.0) Introduced on the M I/O Aggregator. This command issupported in Programmable-Mux (PMUX) mode only.9.2(0.2) ntroduced on the Z9000, S4810, and S4820T.peer-routing-timeoutConfigure the delay after which peer routing is disabled when the peer is unavailable. This command isapplicable for both IPV6/ IPV4.C9000 SeriesSyntax peer-routing-timeout valueTo restore the default value, use the no peer-routing-timeout command.Parameters value Enter the timeout value in seconds. The range is from 1 to65535. The default value is 0 (no timeout).Command Modes VLT DOMAIN (conf-vlt-domain)Command History This guide is platform-specific. For command information about other platforms, referto the relevant Dell Networking OS Command Line Reference Guide.The following is a list of the Dell Networking OS version history for this command.Version Description9.9(0.0) Introduced on the C9010.9.5(0.1) Introduced on the Z9500.9.4(0.0) Added the support for IPV6 / IPV4.9.2(0.2) Introduced on the Z9000, S4810, and S4820T.9.0.2.0 Introduced on the S6000.Usage Information When the timer expires, the software checks to see if the VLT peer is now available. Ifthe VLT peer is not available, peer-routing is disabled on that peer.Virtual Link Trunking (VLT) 2212
