Version Description9.10(0.0) Introduced the Configuration Terminal Batch mode on C9010.9.9(0.0) Introduced on the C9010.9.2(1.0) Introduced on the Z9500.8.3.19.0 Introduced on the S4820T.8.3.11.1 Introduced on the Z9000.8.3.7.0 Introduced on the S4810.8.4.2.0 Introduced on the E-Series TeraScale.8.2.1.0 Introduced on the S-Series.7.8.1.0 Introduced on the C-Series.Usage Information For the new settings to take effect, save the new CAM settings to the startup-config(write-mem or copy run start), then reload the system.You can use the cam-acl-egress command in Configuration Terminal Batch modeto allocate space for egress ACLs in a dual-homing setup.Example Dell#Dell#configureDell(conf)#cam-acl-egress ?default Reset Egress CAM ACL entries to default settingl2acl Set L2-ACL entriesDell(conf)#cam-acl-egress l2acl ?<1-3> Number of FP blocks for l2aclDell(conf)#cam-acl-egress l2acl 1 ?ipv4acl Set IPV4-ACL entriesDell(conf)#cam-acl-egress l2acl 1 ipv4acl 1 ?ipv6acl Set IPV6-ACL entriesDell(conf)#cam-acl-egress l2acl 1 ipv4acl 1 ipv6acl ?<0-2> Number of FP blocks for IPV6 (multiples of 2)Dell(conf)#cam-acl-egress l2acl 1 ipv4acl 1 ipv6acl 2clear counters ipv6 access-groupErase all counters maintained for the IPv6 access lists.C9000 SeriesSyntax clear counters ipv6 access-group [access-list-name]IPv6 Access Control Lists (IPv6 ACLs) 1243
