If you configure both the ip domain-name and ip domain-list commands, thesoftware tries to resolve the name using the ip domain-name command. If the nameis not resolved, the software goes through the list of names configured with the ipdomain-list command to find a match.To enable dynamic resolution of hosts, use the following steps:• specify a domain name server with the ip name-server command• enable DNS with the ip domain-lookup commandTo view current bindings, use the show hosts command. To view a DNS-relatedconfiguration, use the show running-config resolve command.RelatedCommandsip domain-name — specifies a DNS server.ip domain-lookupEnable dynamic host-name to address resolution (that is, DNS).C9000 SeriesSyntax ip domain-lookupTo disable DNS lookup, use the no ip domain-lookup command.Defaults Disabled.Command Modes CONFIGURATIONCommand History This guide is platform-specific. For command information about other platforms, referto the relevant Dell Networking OS Command Line Reference Guide.The following is a list of the Dell Networking OS version history for this command.Version Description9.9(0.0) Introduced on the C9010.9.2(1.0) Introduced on the Z9500.8.3.19.0 Introduced on the S4820T.8.3.11.1 Introduced on the Z9000.8.3.7.0 Introduced on the S4810.8.1.1.0 Introduced on the E-Series ExaScale.7.6.1.0 Introduced on the S-Series.IPv4 Routing 1190
