Version Description9.2(1.0) Introduced on the Z9500.8.3.19.0 Introduced on the S4820T.8.3.11.1 Introduced on the Z9000.8.3.7.0 Introduced on the S4810.7.8.1.0 Introduced on the S-Series.7.6.1.0 Introduced on the C-Series.6.2.1.1 Introduced on the E-Series.Usage Information To enable the interface to send both version of RIP packets, use the ip rip sendversion 1 2 command.RelatedCommandsip rip receive version — sets the RIP version for the interface to receive traffic.version — sets the RIP version for the switch software.ip split-horizonEnable split-horizon for RIP data on the interface. As described in RFC 2453, the split-horizon schemeprevents any routes learned over a specific interface to be sent back out that interface.C9000 SeriesSyntax ip split-horizonTo disable split-horizon, use the no ip split-horizon command.Defaults EnabledCommand Modes INTERFACECommand History This guide is platform-specific. For command information about other platforms, referto the relevant Dell Networking OS Command Line Reference Guide.The following is a list of the Dell Networking OS version history for this command.Version Description9.9(0.0) Introduced on the C9010.9.2(1.0) Introduced on the Z9500.8.3.19.0 Introduced on the S4820T.Routing Information Protocol (RIP) 1895
