The following is a list of the Dell Networking OS version history for this command.Version Description9.9(0.0) Introduced on the C9010.9.6(0.0) Removed from the S-series. Replaced by the dcb-mapcommands.9.0.2.0 Introduced on the S6000.8.3.19.0 Introduced on the S4820T.8.3.12.0 Introduced on the S4810.8.3.16.0 Introduced on the MXL 10/40GbE Switch IO Module.Usage Information To associate a priority group with an ETS output policy with scheduling and bandwidthconfiguration, create a DCB output policy. You can apply a DCB output policy onmultiple egress ports. When you apply an ETS output policy on an interface, ETS-configured scheduling and bandwidth allocation take precedence over any configuredsettings in QoS output policies.The ETS configuration associated with 802.1 priority traffic in a DCB output policy isused in DCBX negotiation with ETS peers.RelatedCommandsdcb-map — to configure PFC and ETS on Ethernet ports that support convergedEthernet traffic.dcb-policy outputApply the output policy with the ETS configuration to an egress interface.C9000 SeriesSyntax dcb-policy output policy-nameTo delete the output policy, use the no dcb-policy output command.Parameters policy-name Enter the output policy name.Defaults noneCommand Modes INTERFACECommand History This guide is platform-specific. For command information about other platforms, referto the relevant Dell Networking OS Command Line Reference Guide.The following is a list of the Dell Networking OS version history for this command.Data Center Bridging (DCB) 698
