Parameters value Enter the timeout value in seconds. The range is from 1 to 1200.The default is 150.Command Modes VLT DOMAIN (conf-vlt-domain)Command History This guide is platform-specific. For command information about other platforms, referto the relevant Dell Networking OS Command Line Reference Guide.The following is a list of the Dell Networking OS version history for this command.Version Description9.9(0.0) Introduced on the C9010.9.5(0.1 Introduced on the Z9500.9.2(0.0) Introduced on the M I/O Aggregator. This command issupported in Programmable-Mux (PMUX) mode only.9.2(0.2) Introduced on the Z9000, S4810, and S4820T.9.0.2.0 Introduced on the S6000.peer-link port-channelConfigure the specified port channel as the chassis interconnect trunk between VLT peers in the domain.C9000 SeriesSyntax peer-link port-channel port-channel-number {peer-down-vlan vlanid}Parameters port-channel-numberEnter the port-channel number that acts as the interconnecttrunk.peer-down-vlanvlan idEnter the keyword peer-down-vlan then a VLAN ID toconfigure the VLAN that the VLT peer link uses when the VLTpeer is down.Defaults Not configured.Command Modes VLT DOMAINCommand History This guide is platform-specific. For command information about other platforms, referto the relevant Dell Networking OS Command Line Reference Guide.The following is a list of the Dell Networking OS version history for this command.Virtual Link Trunking (VLT) 2210
