Version Description7.8.1.0 Introduced on the C-Series and S-Series.7.6.1.0 IntroducedUsage Information The access name is an extended IP access list that denies PIM register packets to RP atthe source DR based on the multicast and group addresses. Do not enter thiscommand before creating the access-list.ip pim rp-addressConfigure a static PIM rendezvous point (RP) address for a group or access-list.C9000 SeriesSyntax ip pim rp-address address {group-address group-address mask}[override]To remove an RP address, use the no ip pim rp-address address {group-address group-address mask} [vrf vrf-name] [override] command.Parameters address Enter the RP address in dotted decimal format (A.B.C.D).group-addressgroup-addressmaskEnter the keywords group-address then a group-addressmask, in dotted decimal format (/xx), to assign that groupaddress to the RP.override Enter the keyword override to override the BSR updates withstatic RP. The override takes effect immediately during enable/disable.NOTE: This option is applicable to multicast group range.Defaults Not configured.Command Modes CONFIGURATIONCommand History This guide is platform-specific. For command information about other platforms, referto the relevant Dell Networking OS Command Line Reference Guide.The following is a list of the Dell Networking OS version history for this command.Version Description9.9(0.0) Introduced on the C9010.9.8(0.0) Introduced on the S3048-ON and S4048-ON.PIM-Sparse Mode (PIM-SM) 1682
