neighbor distribute-listDistribute BGP information via an established prefix list.C9000 SeriesSyntax neighbor {ipv6-address | peer-group-name} distribute-list prefix-list-name {in | out}To delete a neighbor distribution list, use the no neighbor {ipv6-address |peer-group-name} distribute-list prefix-list-name {in | out}command.Parameters ipv6-address Enter the IPv6 address in the x:x:x:x::x format.NOTE: The :: notation specifies successive hexadecimalfields of zeros.peer-group-name Enter the name of the peer group.prefix-list-name Enter the name of an established prefix list. If you do notconfigure the prefix list, the default is permit (to allow allroutes).in Enter the keyword in to distribute only inbound traffic.out Enter the keyword out to distribute only outbound traffic.Defaults Not configured.Command Modes ROUTER BGPV6-ADDRESS FAMILYCommand History Version Description9.9(0.0) Introduced on the C9010.9.2(1.0) Introduced on the Z9500.8.2.1.0 Introduced on the E-Series ExaScale.7.4.1.0 IntroducedUsage Information Other BGP filtering commands include the neighbor filter-list and neighborroute-map commands.RelatedCommands • neighbor filter-list – assigns a AS-PATH list to a neighbor or peer group.• neighbor route-map – assigns a route map to a neighbor or peer group.Border Gateway Protocol 601
