neighbor remote-asCreate and specify the remote peer to the BGP neighbor.C9000 SeriesSyntax neighbor {ipv6-address | peer-group-name} remote-as numberTo delete a remote AS entry, use the no neighbor {ipv6-address | peer-group-name} remote-as number command.Parameters ipv6-address Enter the IPv6 address in the x:x:x:x::x format.NOTE: The :: notation specifies successive hexadecimalfields of zeros.peer-group-name Enter the name of the peer group to enter the remote AS intorouting tables of all routers within the peer group.number Enter a number of the AS. The range is 1 to 65535.Defaults Not configured.Command Modes ROUTER BGPCommand History Version Description9.9(0.0) Introduced on the C9010.9.2(1.0) Introduced on the Z9500.8.2.1.0 Introduced on the E-Series ExaScale.7.4.1.0 IntroducedUsage Information If the number parameter is the same as the AS number used in the router bgpcommand, the remote AS entry in the neighbor is considered an internal BGP peerentry.This command creates a peer and the newly created peer is disabled (shutdown).RelatedCommandsrouter bgp – Enter ROUTER BGP mode and configure routes in an AS.Border Gateway Protocol 609
