Command History This guide is platform-specific. For command information about other platforms, seethe relevant Dell Networking OS Command Line Reference Guide.The following is a list of the Dell Networking OS version history for this command.Version Description9.9(0.0) Introduced on the C9010.9.2(1.0) Introduced on the Z9500.8.3.19.0 Introduced on the S4820T.8.3.11.1 Introduced on the Z9000.8.3.8.0 Introduced on the S4810.Usage Information This command applies the service-policy based on the type of protocol defined in theACL rules.Create ACL and QoS policies prior to enabling this command.If you configure rate-limiting of control protocols on a per-protocol basis and if youmodify the rate using the rate-police command in QOS-POLICY-IN mode whiletraffic is being passed, packet drops for the specified protocols may occur if youconfigure a rate higher than the default rate for a protocol.RelatedCommandsip access-list extended cpu-qos — creates an extended IP ACL for CoPP.mac access-list extended cpu-qos — creates an extended MAC ACL for CoPP.class-map cpu-qos — creates a QoS class map for CoPP.qos-policy-input cpu-qos — creates a QoS input-policy map for CoPP.policy-map-input cpu-qos — creates an input-policy map for CoPP.show control-traffic protocolDisplay per-protocol counters of rate-limited control-plane traffic.C9000 SeriesSyntax show contol—traffic protocol [cp—switch | linecard slot-id portsetport-pipe | pe pe-id stack-unit unit-number portset port-pipe ]countersControl Plane Policing (CoPP) 666
