ip pim query-intervalChange the frequency of PIM Router-Query messages.C9000 SeriesSyntax ip pim query-interval secondsTo return to the default value, use the no ip pim query-interval secondscommand.Parameters seconds Enter a number as the number of seconds between router querymessages. The range is from 0 to 65535. The default is 30seconds.Defaults 30 secondsCommand Modes INTERFACEINTERFACE (BATCH Mode)Command History This guide is platform-specific. For command information about other platforms, referto the relevant Dell Networking OS Command Line Reference Guide.The following is a list of the Dell Networking OS version history for this command.Version Description9.10(0.0) Introduced the Configuration Terminal Batch mode on C9010.9.9(0.0) Introduced on the C9010.9.8(0.0) Introduced on the S3048-ON and S4048-ON.9.7(0.0) Introduced on the S6000-ON.9.5(0.0) Introduced on the Z9500.9.0.2.0 Introduced on the S6000.8.3.19.0 Introduced on the S4820T.8.3.11.1 Introduced on the Z9000.8.3.7.0 Introduced on the S4810.8.1.1.0 Introduced on the E-Series ExaScale.7.8.1.0 Introduced on the C-Series for the port-channels and the S-Series.PIM-Source Specific Mode (PIM-SSM) 1661
