• Multi-supplicant mode authenticates every device attempting to connect to thenetwork on the authenticator port.• Use this command in Interface Batch Mode to enable single-host or multi-hostauthentication in a dual-homing setup.RelatedCommandsshow dot1x interfacedot1x mac-auth-bypassEnable MAC authentication bypass. If 802.1X times out because the host did not respond to the IdentityRequest frame, the system attempts to authenticate the host based on its MAC address.C9000 SeriesSyntax dot1x mac-auth-bypassTo disable MAC authentication bypass on a port, use the no dot1x mac-auth-bypass command.Defaults DisabledCommand Modes INTERFACEINTERFACE (BATCH MODE)Command History This guide is platform-specific. For command information about other platforms, referto the relevant Dell Networking OS Command Line Reference Guide.The following is a list of the Dell Networking OS version history for this command.Version Description9.10(0.0) Introduced the Configuration Terminal Batch mode on C9010.9.9(0.0) Introduced on the C9010.9.2(1.0) Introduced on the Z9500.8.3.19.0 Introduced on the S4820T.8.3.12.0 Introduced on the S4810.8.3.11.1 Introduced on the Z9000.8.4.1.0 Introduced on the C-Series and S-Series.RelatedCommandsdot1x auth-type mab-only802.1X 249
