linecard portmodeSplit a single 40G port into four 10G ports on the switch.C9000 SeriesSyntax linecard slot-id port number portmode quadParameters linecard slot-id Enter the slot ID of a line card to reset. The range of slot IDs isfrom 0 to 11.number Enter the port number of the 40G port to be split. The portrange is from 0 to 20. A 40G port number is a multiple of 4; forexample, 0, 4, 8, 12, ... 120, 124, 128).Defaults Disabled.Command Modes CONFIGURATIONCommand History This guide is platform-specific. For command information about other platforms, referto the relevant Dell Networking OS Command Line Reference Guide.The following is a list of the Dell Networking OS version history for this command.Version Description9.9(0.0) Introduced on the C9010.9.2(1.0) Introduced on the Z9500.Usage Information Enabling quad mode on a port removes the interface configurations (if any) on the portafter a save and reload. Be sure that the port is removed from other L2 and L3 featureconfigurations.You must save and reload the system for the 40G to 4x10G port change to take effect.This command cannot be used if LR4 optics are inserted in the 40G port.Interfaces 945
