• sflow collector• sflow enable (Global)• sflow enable (Interface)• sflow ingress-enable• sflow extended-switch enable• sflow max-header-size extended• sflow polling-interval (Global)• sflow polling-interval (Interface)• sflow sample-rate (Global)• sflow sample-rate (Interface)• show sflow• show sflow linecardsflow collectorConfigure a collector device to which sFlow datagrams are forwarded.C9000 SeriesSyntax sflow collector {ip-address | ipv6-address} agent-addr {ip-address| ipv6-address} [number [max-datagram-size number]] | [max-datagram-size number] [vrf management]To delete a configured collector, use the no sflow collector {ip-address |ipv6-address} agent-addr {ipv4-address | ipv6-address} [number[max-datagram-size number]] | [max-datagram-size number] [vrfmanagement] command.Parameters sflow collector ip-address | ipv6-addressEnter the IP address of the collector in dotted decimal formatfor IPv4 or x:x:x:x::x format for IPv6.NOTE: The :: notation specifies successive hexadecimalfields of zeros.agent-addr ip-address | ipv6-addressEnter the keyword agent-addr followed by the sFlow agent IPaddress in dotted decimal format for IPv4 or x:x:x:x::x format forIPv6.NOTE: The :: notation specifies successive hexadecimalfields of zeros.number (OPTIONAL) Enter the user datagram protocol (UDP) portnumber. The range is from 0 to 65535. The default is 6343.sFlow 2025
