Default To reset the number FP blocks allocated for ACL VLAN processes, enter the defaultkeyword with the cam-acl-vlan command. By default, 0 FP blocks are allocated forACL VLAN operations on the switch.Command Modes ACL-VLAN-GROUP CONFIGURATIONCONFIGURATION TERMINAL BATCHCommand History Version Description9.10(0.0) Introduced the Configuration Terminal Batch mode on C9010.9.9(0.0) Introduced on the C9010.9.5(0.1) Introduced on the Z9500.9.3(0.0) Introduced on the S4810 and Z9000.Usage Information The VLAN ContentAware Processor (VCAP) application is a pre-ingress CAP thatmodifies the VLAN settings before packets are forwarded. To support the ACL CAMoptimization functionality, the CAM carving feature is enhanced. A total of four VACPgroups are present, of which two are for fixed groups and the other two are fordynamic groups. Out of the total of two dynamic groups, you can allocate zero, one, ortwo flow processor (FP) blocks to iSCSI counters, Open Flow and ACL VLANoptimization. You can configure CAM FP blocks for only two of these ACL VLANservices at a time. Use this command in Configuration Terminal Batch mode toconfigure in a dual-homing setup.description (ACL VLAN Group)Add a text description of an ACL VLAN group.C9000 SeriesSyntax description textParameters description Enter a text to identify the ACL VLAN group (80 charactersmaximum).Default No default behavior or valuesCommand Modes ACL-VLAN-GROUP CONFIGURATION (conf-acl-vl-grp)Command History Version Description9.9(0.0) Introduced on the C9010.9.5(0.0) Introduced on the Z9500.Access Control Lists (ACL) 322
