period minutes Enter a duration in which to allow a number of automaticfailovers (limited to the number defined in the count parameter).The range is from 5 to 9000 minutes. The default is 60 minutes.Default • Count: 3• Period: 60 minutesCommand Modes CONFIGURATIONCommand History This guide is platform-specific. For command information about other platforms, referto the relevant Dell Networking OS Command Line Reference Guide.The following is a list of the Dell Networking OS version history for this command.Version Description9.9(0.0) Introduced on the C9010.8.3.19.0 Introduced on the S4820T.8.3.12.0 Introduced on the S4810.8.1.1.0 Introduced on the E-Series ExaScale.7.5.1.0 Introduced on the C-Series.7.6.1.0 Introduced on the E-SeriesUsage Information If you disable auto failover, enter the redundancy auto-failover-limit (withoutany parameters) to set auto failover to the default parameters (Count 3, Period 60minutes). To view the redundancy status, use the show redundancy command.When you change one or both of the optional parameters, Dell Networking OS checksthat the interval between auto failovers is more than five (5) minutes. If the interval isless, Dell Networking OS returns a configuration error message.redundancy disable-auto-rebootPrevent the system from auto-rebooting the failed module.C9000 SeriesSyntax redundancy disable-auto-reboot {linecard [slot—id | all] | pe pe-id stack unit unit-number | all | rpm}High Availability (HA) 909
