Usage Information For the new settings to take effect, save the new CAM settings to the startup-config(write-mem or copy run start) then reload the system.The total amount of space allowed is 16 FP Blocks. System flow requires four blocksand these blocks cannot be reallocated. The total number of blocks must be equal to12. The ipv4acl profile range is from 0 to 8.When configuring space for IPv6 ACLs, the total number of Blocks must equal 12.Ranges for the CAM profiles are from 1 to 10, except for the ipv6acl profile which isfrom 0 to 10. The ipv6acl allocation must be a factor of 2 (2, 4, 6, 8, 10).If you enabled BMP 3.0, to perform a reload on the chassis to upgrade anyconfiguration changes that have changed the NVRAM content, use the reloadconditional nvram-cfg-change command.You can use the cam-acl default command in Configuration Terminal Batch modeto reset ACL CAM entries to default settings in a dual-homing setup.cam-audit linecardEnable audit of the IPv4 forwarding table on all line cards.C9000 SeriesSyntax cam-audit linecard all ipv4-fib interval time-in-minutesParameters all Enter the keyword all to enable CAM audit on all line cards.ipv4-fib Enter the keyword ipv4-fib to designate the CAM audit on theIPv4 forwarding entries.interval time-in-minutesEnter the keyword interval followed by the frequency inminutes of the CAM audit. Range: 5 to 1440 minutes (24 hours).Default: 60 minutes.Defaults DisabledCommand Modes CONFIGURATIONCONFIGURATION TERMINAL BATCHCommand History Version Description9.10(0.0) Introduced the Configuration Terminal Batch mode on C9010.Control and Monitoring 77
