There can be only one odd number of Blocks in the CLI configuration; the other Blocksmust be in factors of 2. For example, a CLI configuration of 5+4+2+1+1 Blocks is notsupported; a configuration of 6+4+2+1 Blocks is supported.The ipv6acl allocation must be a factor of 2.If allocation values are not entered for the CAM regions, the value is 0.If you enable BMP, to perform a reload on the chassis to upgrade any configurationchanges that have changed the NVRAM content, use the command reloadconditional nvram-cfg-change.cam-acl-egressAllocate CAM for egress ACLs.C9000 SeriesSyntax cam-acl-egress default | l2acl number ipv4acl number ipv6aclnumber}Parameters default Reset egress CAM ACL entries to default settings.l2acl numberipv4acl numberipv6acl numberAllocate space to each CAM region.Enter the CAM profile name then the amount of CAM space tobe allotted. The total space allocated must equal 13. The rangefor ipv4acl is from 1 to 4. The ipv6acl range must be a factor of2.Command Modes CONFIGURATIONCONFIGURATION TERMINAL BATCHCommand History This guide is platform-specific. For command information about other platforms, referto the relevant Dell Networking OS Command Line Reference Guide.The following is a list of the Dell Networking OS version history for this command.Version Description9.10(0.0) Introduced the Configuration Terminal Batch mode on C9010.9.9(0.0) Introduced on the C9010.9.2(1.0) Introduced on the Z9500.8.3.19.0 Introduced on the S4820T.Content Addressable Memory (CAM) 647
