To remove the advertised dot3–tlv, use the no advertise dot3–tlv power-via-mdi commandParameters power-via-mdi Enter the keyword power—via-mdi to advertise IEEE 802.3atpower-via-mdi TLV.Defaults DisabledCommand Modes • LLDP CONFIGURATION (conf-lldp)• INTERFACE LLDP CONFIGURATION (conf-if-interface-lldp)Command History This guide is platform-specific. For command information about other platforms, referto the relevant Dell Networking OS Command Line Reference Guide.The following is a list of the Dell Networking OS version history for this command.Version Description9.9(0.0) Introduced on the C9010.Usage Information The advertise dot3–tlv power—via—mdi command enables the system toadvertise IEEE 802.3at power-via-mdi TLV to advertise its power negotiationcapabilities with the powered devices via Link Layer Discovery Protocol (LLDP). You canconfigure this command either on a specific interface or globally.Example Dell(conf)#interface peGigE 0/0/0Dell(conf-if-pegi-0/0/0)#protocol lldpDell(conf-if-pegi-0/0/0-lldp)#advertise dot3-tlv power-via-mdiDell(conf-if-pegi-0/0/0-lldp)#advertise management-tlvAdvertise management TLVs (Type, Length, Value).C9000 SeriesSyntax advertise management-tlv {management-address | system-capabilities| system-description | system-name}To remove advertised management TLVs, use the no advertise management-tlv{management-address | system-capabilities | system-description |system-name} command.Parameters management-addressEnter the keyword management-address to advertise themanagement IP address TLVs to the LLDP peer.Link Layer Discovery Protocol (LLDP) 1362
