channel-memberAdd an interface to the Port Channel, while in INTERFACE PORTCHANNEL mode.C9000 SeriesSyntax channel-member interfaceTo delete an interface from a Port Channel, use the no channel-member interfacecommand.Parameters interface (OPTIONAL) Enter any of the following keywords and slot/port,peid/stack-unit/port-id, or number information:• For a Gigabit Ethernet interface, enter the keywordGigabitEthernet then the slot/port information.• For a 10-Gigabit Ethernet interface, enter the keywordTenGigabitEthernet then the slot/port information.• For a 40-Gigabit Ethernet interface, enter the keywordfortyGigE then the slot/port information.• For a port extender Gigabit Ethernet interface, enter thekeyword peGigE then the pe-id / stack-unit / port-idinformation. The pe-id range is from 0 to 255; the stack-unit unit-number range is from 0 to 7; and the port-idrange is from 1 to 48.Defaults Not configured.Command Modes INTERFACE PORTCHANNELCommand History This guide is platform-specific. For command information about other platforms, seethe relevant Dell Networking OS Command Line Reference Guide.The following is a list of the Dell Networking OS version history for this command.Version Description9.9(0.0) Introduced on the C9010.9.2(1.0) Introduced on the Z9500.8.3.19.0 Introduced on the S4820T.8.3.11.1 Introduced on the Z9000.8.5.1.0 Added support for 4-port 40G line cards on ExaScale.8.3.7.0 Introduced on the S4810.8.1.1.0 Introduced on the E-Series ExaScale.Interfaces 1018
