debug ip icmpView information on the internal control message protocol (ICMP).C9000 SeriesSyntax debug ip icmp [interface] [count value]To disable debugging, use the no debug ip icmp command.Parameters interface (OPTIONAL) Enter the following keywords and slot/port ornumber information:• For the Management interface, enter the keywordManagementEthernet then the slot/port information. Theslot range is from 0 to 1 and the port range is 0.• For a Port Channel interface, enter the keywords port-channel then a number. The range is from 1 to 128.• For a Tunnel interface, enter the keywords tunnel then anumber. The range is from 1 to 16383.• For a 10-Gigabit Ethernet interface, enter the keywordTenGigabitEthernet then the slot/port information.• For a 40-Gigabit Ethernet interface, enter the keywordfortyGigE then the slot/port information.• For a port extender (PE) Gigabit Ethernet interface, enterthe keyword peGigE then the pe-id/stack-unit/portinformation.• For a VLAN, enter the keyword vlan then a number from 1to 4094.count value (OPTIONAL) Enter the keyword count then the count value. Therange is from 1 to 65534. The default is Infinity.Command Modes EXEC PrivilegeCommand History This guide is platform-specific. For command information about other platforms, referto the relevant Dell Networking OS Command Line Reference Guide.The following is a list of the Dell Networking OS version history for this command.Version Description9.9(0.0) Introduced on the C9010.9.2(1.0) Introduced on the Z9500.IPv4 Routing 1181
