• null — Causes an encryption policy configured for the areato not be inherited on the interface.Defaults noneCommand Modes CONFIGURATIONCommand History This guide is platform-specific. For command information about other platforms, referto the relevant Dell Networking OS Command Line Reference Guide.The following is a list of the Dell Networking OS version history for this command.Version Description9.9(0.0) Introduced on the C9010.9.2(1.0) Introduced on the Z9500.9.2(0.0) Introduced on the Z9000, S4810, and S4820T.Usage Information • Both sides of the link must specify the same transform set.• You can create up to 64 transform sets.Example Dell(conf)#int ten 0/4Dell(conf-if-te-0/4)#ipv6 address 200:1::/64 eui64Dell(conf)#int ten 0/6Dell(conf-if-te-0/6)#ipv6 address 801:10::/64 eui64crypto ipsec policyCreate a crypto policy used by ipsec.C9000 SeriesSyntax crypto ipsec policy name seq-num ipsec-manualTo delete a crypto policy entry, use the no crypto ipsec policy name seq-numipsec-manual command.Parameters name Enter the name for the crypto policy set.seq-num Enter the sequence number assigned to the crypto policy entry.Defaults noneCommand Modes CONFIGURATIONInternet Protocol Security (IPSec) 1157
