RelatedCommandsclear hardware system-flow — clears the statistics from selected hardwarecomponents.show system — displays the current status of all the stack members or a specificmember.stack unitPre-provision the specified port-extender stack unit.C9000 SeriesSyntax stack-unit unit-number {type unit-type | priority value}To de-provision or delete a port extender stack unit, use the no stack-unit unit-number {type unit-type | priority value} command.Parameters stack-unit unit-numberEnter the stack-unit ID number to locate a specific stack unit.Stack unit number range is 0–7.type PE-type Enter a value for the stack-unit type. The only support value forstack-unit type is C1048P.priority value Enter the master priority value for the unit. The priority valuerange is from 1 to 14. The unit with the numerically highestpriority value is elected the master.Default NoneCommand Modes PE CONFIGCommand History This guide is platform-specific. For command information about other platforms, seethe relevant Dell Networking OS Command-Line Reference Guide.The following is a list of the Dell Networking OS version history for this command.Version Description9.9(0.0) Introduced on the C9010.Usage Information You can pre-provision a port extender stack unit using the stack unit command inthe PE configuration mode and specify the stack-unit type. Only similar types of stackunits are provisioned under a single port extender. The maximum number of stack unitsallowed for provisioning is 8. In a PE stack, by default, the stack unit with the highestMAC address is elected master; the stack unit with the second highest MAC address isPE Stacking 1637
