Configuration of IPv6 commands over decapsulate-any tunnel causes an error.tunnel sourceSet a source address for the tunnel.C9000 SeriesSyntax tunnel source {ip-address | ipv6–address | interface-type-number |anylocal}To delete the current tunnel source address, use the no tunnel source command.Parameters ip-address Enter the source IPv4 address in A.B.C.D format.ipv6–address Enter the source IPv6 address in X:X:X:X::X format.interface-type-number • For a port channel interface, enter the keywords port-channel then a number from 1 to 128.• For a 10-Gigabit Ethernet interface, enter the keywordTenGigabitEthernet then the slot/port information.• For a VLAN interface, enter the keyword vlan then anumber from 1 to 4094.anylocal Enter the anylocal command to allow the multipoint receive-only tunnel to decapsulate tunnel packets destined to any localip address.Defaults noneCommand Modes INTERFACE TUNNEL (conf-if-tu)Command History Version Description9.9(0.0) Introduced on the C9010.9.7(0.0) Introduced on the S6000-ON.9.4(0.0) Added the tunnel source anylocal command.9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.Usage Information Added an optional keyword “anylocal” to the tunnel source command. The anylocalargument can be used in place of the ip address or interface, but only with theTunneling Commands 2189
