Dell(config-if-range)# no shutdownDell(config-if-range)#Example (MultipleRange)This example shows how to use commas to add VLAN and port-channel interfaces tothe range.Dell(config-if)# interface range tengigabitethernet 2/1-23,tengigabitethernet 1/1–2,Vlan 2–100, Port 1–25Dell(config-if-range)# no shutdownDell(config-if-range)#RelatedCommands • interface port-channel — configures a port channel group.• interface vlan — configures a VLAN interface.• show config (from INTERFACE RANGE mode) — shows the bulk configurationinterfaces.• show range — shows the bulk configuration ranges.• interface range macro (define) — defines a macro for an interface-range.interface range macro (define)Defines a macro for an interface range and then saves the macro in the running configuration.C9000 SeriesSyntax define interface range macro name interface , interface , ...Parameters name Enter up to 16 characters for the macro name.interface,interface,...Enter the keywords interface range and one of theinterfaces — slot/port, pe-id/stack-unit/port-id, port-channel, orVLAN number. Select the range of interfaces for bulkconfiguration. You can enter up to six comma-separated ranges.Spaces are not required between the commas. Comma-separated ranges can include VLANs, port-channels, andphysical interfaces.Slot/Port information must contain a space before and after thedash. For example, interface range tengigabitethernet0/1 - 5 is valid; interface range tengigabitethernet0/1-5 is NOT valid.• For a Port Channel interface, enter the keywords port-channel then a number. The range is from 1 to 128.• For a 10-Gigabit Ethernet interface, enter the keywordTenGigabitEthernet then the slot/port information.Interfaces 940
