Usage Information This command allows you to create an EUI64 address based on the specified prefix andMAC address only. Prefixes may be configured on the interface using the ipv6 ndprefix command without creating an EUI64 address.Example Dell(conf)#int ten 0/4Dell(conf-if-te-0/4)#ipv6 address 200:1::/64 eui64Dell(conf)#int ten 0/6Dell(conf-if-te-0/6)#ipv6 address 801:10::/64 eui64ipv6 control-plane icmp error-rate-limitConfigure the maximum number of ICMP error packets generated and sent in one second.C9000 SeriesSyntax ipv6 control-plane icmp error-rate-limit {1-200}To restore the default value, use the no ipv6 control-plane icmp error-rate-limit command.Parameters pps Enter the maximum number of error packets generated persecond. The range is from 1 to 200.Default 100 ppsCommand Modes CONFIGURATIONCommand History This guide is platform-specific. For command information about other platforms, referto the relevant Dell Networking OS Command Line Reference Guide.The following is a list of the Dell Networking OS version history for this command.Version Description9.9(0.0) Introduced on the C9010.9.2(1.0) Introduced on the Z9500.8.3.19.0 Introduced on the S4820T.8.3.11.1 Introduced on the Z9000.8.3.7.0 Introduced on the S4810.IPv6 Basics 1273
