primary-priorityAssign the priority for master election among VLT peers.C9000 SeriesSyntax [no] primary-priorityParameters value To configure the primary role of a VLT peer in a VLT domain,enter a lower value than the priority value of the remote peer.The range is from 1 to 65535.Default 32768Command Modes VLT DOMAINCommand History This guide is platform-specific. For command information about other platforms, referto the relevant Dell Networking OS Command Line Reference Guide.The following is a list of the Dell Networking OS version history for this command.Version Description9.9(0.0) Introduced on the C9010.9.5(0.1) Introduced on the Z9500.9.2(0.0) Introduced on the M I/O Aggregator. This command issupported in Programmable-Mux (PMUX) mode only.9.0.2.0 Introduced on the S6000.8.3.19.0 Introduced on the S4820T.8.3.8.0 Introduced on the S4810.Usage Information After you configure a VLT domain on each peer switch and connect (cable) the twoVLT peers on each side of the VLT interconnect, the system elects a primary andsecondary VLT peer device. To configure the primary and secondary roles before theelection process, use the primary-priority command. Enter a lower value on theprimary peer and a higher value on the secondary peer.If the primary peer fails, the secondary peer (with the higher priority) takes the primaryrole. If the primary peer (with the lower priority) later comes back online, it is assignedthe secondary role (there is no preemption).Virtual Link Trunking (VLT) 2213
