vlan vlan-id (OPTIONAL) Enter the keyword vlan then a VLAN ID to policetraffic to those specific VLANs. The range is from 1 to 4094.Defaults Granularity for commited-rate and peak-rate is Mbps unless you use the kbpsoption.Command Modes INTERFACECommand History This guide is platform-specific. For command information about other platforms, referto the relevant Dell Networking OS Command Line Reference Guide.The following is a list of the Dell Networking OS version history for this command.Version Description9.9(0.0) Introduced on the C9010.9.2(1.0) Introduced on the Z9500.8.3.19.0 Introduced on the S4820T.8.3.11.1 Introduced on the Z9000.8.3.7.0 Introduced on the S4810.8.2.1.0 Added the kbps option on the C-Series, E-Series, and S-Series.7.6.1.0 Introduced on the S-Series.7.5.1.0 Introduced on the C-Series.6.1.1.1 Introduced on the E-Series.Usage Information NOTE: Per Port rate limit and rate police is supported for Layer 2 tagged anduntagged switched traffic and for Layer 3 traffic. Per VLAN rate limit and ratepolice is supported on only tagged ports with Layer 2 switched traffic.On one interface, you can configure the rate police command for a VLAN or youcan configure the rate police command for an interface. For each physicalinterface, you can configure three rate police commands specifying differentVLANS.RelatedCommandsrate-police — specifies traffic policing on the selected interface.rate shapeShape the traffic output on the selected interface.C9000 SeriesSyntax rate shape [kbps] rate [burst-KB]Quality of Service (QoS) 1797
