ipv6–address Enter the destination IPv6 address for the tunnel.Defaults noneCommand Modes INTERFACE TUNNEL (conf-if-tu)Command History Version Description9.9(0.0) Introduced on the C9010.9.7(0.0) Introduced on the S6000-ON.9.3(0.0) Introduced on the S4810, S4820T, S6000 and Z9000.Usage Information The tunnel interface is inoperable without a valid tunnel destination address for theconfigured Tunnel mode.To establish a logical tunnel to the particular destination address, use the destinationaddress of the outer tunnel header. If you configure a tunnel interface or sourceaddress, the tunnel destination must be compatible.tunnel dscpConfigure the method to set the DSCP in the outer tunnel header.C9000 SeriesSyntax tunnel dscp {mapped | value}To use the default tunnel mapping behavior, use the no tunnel dscp valuecommand.Parameters mapped Enter the keyword mapped to map the original packet DSCP(IPv4)/Traffic Class (IPv6) to the tunnel header DSCP (IPv4)/Traffic Class (IPv6) depending on the mode of tunnel.value Enter a value to set the DSCP value in the tunnel header. Therange is from 0 to 63. The default value of 0 denotes mapping oforiginal packet DSCP (IPv4)/Traffic Class (IPv6) to the tunnelheader DSCP (IPv4)/Traffic Class (IPv6) depending on the modeof tunnel.Defaults 0 (Mapped)Command Modes INTERFACE TUNNEL (conf-if-tu)Tunneling Commands 2184
