RelatedCommands • interface ManagementEthernet — configures the Management port on the system(either the Primary or Standby RPM).• management route — configures a static route that points to the Managementinterface or a forwarding router.• speed (Management interface) — sets the speed on the Management interface.flowcontrolEnable and disable link-level flow control (802.3x pause frames) on an interface and (optionally) configurebuffer thresholds for pause and offset frame transmission.C9000 SeriesSyntax flowcontrol rx {off | on} tx {off | on} [pause-threshold{1-12480}] [resume-offset {1-12480}]Parameters rx on Enter the keywords rx on to process the received flow controlframes on this port.rx off Enter the keywords rx off to ignore the received flow controlframes on this port.tx on Enter the keywords tx on to send control frames from the portto the connected device when a higher rate of traffic is received.tx off Enter the keywords tx off so that flow control frames are notsent from this port to the connected device when a higher rateof traffic is received.pause-threshold Enter the keyword pause-threshold to configure the bufferthreshold (in Kilobytes) at which the interface starts transmittingpause frames for link-level flow control. Valid values are 1 to12480KB. The default is 60KB.resume-offset Enter the keyword resume-offset to configure the bufferthreshold (in Kilobytes) at which the interface resumestransmitting offset frames for link-level flow control. Valid valuesare 1 to 12480KB. The default is 9KB.Defaults An interface ignores flow-control frames received from other network devices (rx off)and does not transmit pause frames (tx off).Command Modes INTERFACECommand History This guide is platform-specific. For command information about other platforms, seethe relevant Dell Networking OS Command Line Reference Guide.The following is a list of the Dell Networking OS version history for this command.Interfaces 929
