Version Description9.9(0.0) Introduced on the C9010.9.7(0.1) Introduced on the S3048-ON and S4048-ON .9.7(0.0) Introduced on the S6000-ON.9.0.2.0 Introduced on the S6000.8.3.19.0 Introduced on the S4820T.8.3.12.0 Introduced on the S4810.8.3.16.0 Introduced on the MXL 10/40GbE Switch IO Module.Usage Information By default, iSCSI is enabled on the unit and the flow control is enabled on all of theinterfaces. It is also acts as defaults when the link-level flow control is enabled on oneor more interfaces.To enable DCB, do one of the following:• Apply the dcb-input policy command with the no pfc-mode command onto all the interfaces.• Disable flow-control on all of the interfaces.Enables priority flow control or enhance transmission selection on interface.RelatedCommandsdcb enable — enable priority flow control or enhanced transmissionselection on interface.dcb-outputTo associate an ETS configuration with priority traffic, create a DCB output policy.C9000 SeriesSyntax dcb-output policy-nameTo remove the ETS output policy globally, use the no dcb output policy-namecommand.Parameters policy-name Enter the DCB output policy name. The maximum is 32alphanumeric characters.Defaults noneCommand Modes CONFIGURATIONCommand History This guide is platform-specific. For command information about other platforms, referto the relevant Dell Networking OS Command Line Reference Guide.Data Center Bridging (DCB) 697
